Correct operation procedures of plastic granulator:
The practical operation is carried out by the operators who are trained and familiar with the structural performance and operation procedures of plastic mechanical equipment. The correct use of plastic granulator can greatly reduce the mechanical failure and mechanical damage caused by wrong operation, and greatly extend the machine and reliability.
Before start-up, check the mechanical and electrical parts, check whether the connecting bolts are loose, whether the lubrication of each lubricating point is normal, whether the transmission device is normal and reliable, whether the protective device is intact, whether the electrical instruments are sensitive, and whether the motor carbon brush is in good contact.
The feed particle size shall be strictly in accordance with the feed particle size specified by various models, and it is forbidden to enter the crusher with material particle size larger than the specified one, otherwise it will cause imbalance of impeller and excessive wear of impeller, and even cause blockage of impeller flow channel and central feed pipe, so that the crusher can not work normally. When large materials are found, they shall be removed in time.
During the actual operation of the plastic granulator, if the material temperature does not reach the set temperature and the holding time is not enough, it is not allowed to start up and run the extruder screw.
The actual operation of the plastic granulator shall be in strict accordance with the requirements of the operating procedures, and shall not be carried out in non operating positions. Ensure the reliability of safety devices.
The practical operation is carried out by the operators who are trained and familiar with the structural performance and operation procedures of plastic mechanical equipment. The correct use of plastic granulator can greatly reduce the mechanical failure and mechanical damage caused by wrong operation, and greatly extend the machine and reliability.
Before start-up, check the mechanical and electrical parts, check whether the connecting bolts are loose, whether the lubrication of each lubricating point is normal, whether the transmission device is normal and reliable, whether the protective device is intact, whether the electrical instruments are sensitive, and whether the motor carbon brush is in good contact.
The feed particle size shall be strictly in accordance with the feed particle size specified by various models, and it is forbidden to enter the crusher with material particle size larger than the specified one, otherwise it will cause imbalance of impeller and excessive wear of impeller, and even cause blockage of impeller flow channel and central feed pipe, so that the crusher can not work normally. When large materials are found, they shall be removed in time.
During the actual operation of the plastic granulator, if the material temperature does not reach the set temperature and the holding time is not enough, it is not allowed to start up and run the extruder screw.
The actual operation of the plastic granulator shall be in strict accordance with the requirements of the operating procedures, and shall not be carried out in non operating positions. Ensure the reliability of safety devices.
website：/en/news_view_142_112.html
